Parker Suregrip Digi-Pull Mig Series, Руководство пользователя

Страница: 5 / 12

1
2
4
3
5
Digi-novus ®Two wire Digital BUS system©
Within the torch package is an Interface board. This board acts as the Digi-novus interface between the power source and the Digi-
pull torch.
The system is designed to be a universal addition to any Digital Mig welding machine or power source, and once installed will enable
the equipment to accept either digital or traditional torches without the need for further adjustments.
This interface acts as a “Translator” BUS so that control wire signals, together with the torch power supply and digital signals are
transmitted in a language understood by the Digi-Pull torch.
The Interface is designed to automatically recognize digital signals when such products are offered to the machine and is capable of
accepting and recognizing non-digital models. This includes the Parker range of Digi-Mig welding torches.
When traditional torches are connected, the power source automatically reverts back to its normal operation.
Parker team of specialist technical engineers is available to provide assistance to specifiers to enable them to select the
most appropriate model and to give advice with the installation of the necessary software.
Note: some machine types may already have integrated interface board inside machine. Please check your machine manual for
details. If a board is fitted then there is no need to take further action.
Drive head set up
Setting up the Pull-Mig torch is a simple process but before starting check that you have the correct drive roll for the wire you
will be using. The size is marked on the drive roll.
Main components of the drive head.
1 Pressure rolll
2 Pull-Mig Handle cover
3 Drive roll
4 Tension knob
5 Pressure arm
6 Neck liner nipple
5
The selected function can then be changed by holding down either the upperfinger pad to increase or the lower finger pad to
decrease. Once set, the unit can be de-activated by switching it off by pressing and holding the mode switch (M) . This will prevent a
ccidental changes to the chosen settings during the welding operation. When re-activated, the unit returns to the current setting.