isysNet 32 Point Valve Driver, Series A (PSSV32A)
E100P
3
Mount the I/O Base
To mount the I/O base on a wall or panel, use the screw holes
provided in the base.
IMPORTANT
The I/O module must be mounted on a grounded metal mounting
plate or other conductive surface.
A mounting illustration for the base with an adapter is shown below.
Inches
(mm)
Adapter
2.0
(50)
2.0
(50)
1.9
(47.2)
4.02
(102)
1.81
(46)
4.32
(109.8)
5.39
(137.0)
Drill and Tap
for M4 Screw
2.39
(60.7)
3.02
(76.6)
3.13
(79.4)
5.98*
(151.9)
0.87
(22)
Drill and Tap
for M6 Screw
Install the 32 Point Valve Driver
To Install the 32 Point Valve Driver, Proceed as Follows:
1. Assemble the valve driver to the manifold interface plate using
four M4 screws, torqued 11 to 13 in. lbs.
2. Plug the 32 point valve driver onto the previous mounting base
or communication adapter.
Wire the 32 Point Valve Driver
Following are wiring instructions for the 32 point valve driver.
Use the appropriate harness assembly based on your manifold
wiring/interconnect system.
Harness Assembly Kit Numbers
1 to 24 Outputs
25 to 32 Outputs
HA, HB
PS5624P
PS5632P
H1, H2, H3
PS4024P
PS4032P
Plug the 2X15 connector into the valve driver module for 1-24 outputs.
If you have more than 24 outputs, plug the 2X5 connector into the
valve driver module for 25-32 outputs.
Plug the 2X10 and 1X10 connectors into the interconnect board in
the valve manifold.
EDS File Requirements
The EDS file is available online at www.parker.com/pneu/isysNet.
Make sure all four screws are securely tightened to properly seal
the connections against leaks and maintain IP67 requirements.
!
ATTENTION
Outputs
25- 32
Connector
Outputs
1- 24
Connector
* Depending on the type and number of manifolds, this dimension
may vary. Refer to Catalog 0600P-# for additional information.
