RS9 Hard Drive Installation
6
CTC Parker Automation
3. Tighten the four retaining screws.
4. If this is a first-time installation, fasten the free end of the ribbon
cable to its connector on the riser card.
This connector is directly below the bottom of the hard drive,
behind the cable connector for the CD-ROM drive.
5. If necessary, re-attach the CD-ROM drive cable to its connector
on the riser card.
6. If you have removed the power supply from the unit, replace it by
following these steps:
a.
Place the RS9/RSPC9 unit on its back.
b. Replace the power supply in the unit, aligning the screw holes
in the bottom of the power supply with those in the bottom of
the unit.
c.
Replace the four screws that secure the power supply in place
and that you removed in step 4 on page 4. Be sure to replace
the nuts with screws 1 and 2.
d. Re-attach the two sets of cables that you disconnected from
the power supply in step 2 on page 4.
e.
Turn the backshell upright.
Reassembling the Unit
To reassemble the unit, follow these steps:
1. Close the front cover, and fasten it in place with the two screws
that you removed in step 6 on page 1.
2. Reinstall the unit in its mounted location.
3. Reconnect power and other cables to the unit.
4. Reconnect the unit to the power source.
Your hard drive installation or replacement is complete. You may now
restart the system.