When cutting, make sure that sparks are
exiting from the bottom of the workpiece.
Hand torch cutting technique
If sparks are spraying up from the
workpiece, you are moving the torch too
fast, or without sufficient power.
Hold the torch vertically and watch the arc
as it cuts along the line.
•
It is easier to pull the torch through the cut than to push it.
•
To cut thin material, reduce the amps until you get the best quality cut.
•
For straight-line cuts, use a straight edge or a cutting buggy as a guide. To cut circles, use a template or a circle cutting attachment .
•
Dependant upon the cutting method required, different torches have different front end set-ups to help improve ease of use. Please
refer to the wear parts configurator section in the wear parts manual for options, or go to our web site www.parkertorchology.com.cn.
•
After the torch trigger switch is released, the gas will continue to flow for at least 60 seconds to cool the torch and consumables.
This helps to cool the torch and prolong the life of the consumables.
Operation and Start Up
Some tips and advice to help you get going
Hold the torch vertical at the edge of the
workpiece.
Starting a cut
Pull the trigger to start the pilot arc.
The cutting arc will initiate when the torch
parts are in the correct proximity to the
workpiece. Start cutting at the edge until
the arc has completely cut through the
workpiece.
Then, proceed with the cut.
Tips
Copyright, all rights reserved
7
Содержание Plasma Cutting Series
Страница 1: ...Plasma Cutting Series OWNER S HANDBOOK ...
Страница 9: ......
