2
Special considerations
2 Precautions
Instruction book, IQAN- G3
2
Precautions
Work on the hydraulics control electronics may only be carried out by trained
personnel who are well-acquainted with the control system, the machine and its safety
regulations.
W
ARNING
Make sure that you have sufficient knowledge before designing, modifiying or
servicing the control system.
Read the relevant sections of this document before conducting any work on the control
system.
W
ARNING
This product is not field repairable.
N
OTICE
As much as possible of the welding work on the chassis should be done before the
installation of the system. If welding has to be done afterwards, the electrical
connections on the system must be disconnected from other equipment. The negative
cable must always be disconnected from the battery before disconnecting the positive
cable. The ground wire of the welder shall be positioned as close as possible to the
place of the welding. The cables on the welding unit shall never be placed near the
electrical wires of the control system.
Special considerations
Health Care
When in a hospital or other health care facility, observe the restrictions on the use of
mobiles. Switch the IQAN-G3 off, if instructed to do so by the guidelines posted in
sensitive areas. Medical equipment may be sensitive to RF energy.
The operation of cardiac pacemakers, other implanted medical equipment and hearing
aids can be affected by interference from IQAN-G3’s antennas placed close to the
device. If in doubt about potential danger, contact the physician or the manufacturer of
the device to verify that the equipment is properly shielded. Pacemaker patients are
advised to keep the IQAN-G3 and its antennas away from the pacemaker while it is on.
Air traffic
Switch off the IQAN-G3 before boarding an aircraft. Make sure it cannot be switched
on inadvertently. The operation of wireless appliances in an aircraft is forbidden to
prevent interference with communications systems. Failure to observe these
instructions may lead to the suspension or denial of cellular services to the offender,
legal action, or both.
Explosives
Do not operate the IQAN-G3 in the presence of flammable gases or fumes. Switch off
the IQAN-G3 when you are near petrol stations, fuel depots, chemical plants or where
blasting operations are in progress. Operation of any electrical equipment in potentially
explosive atmospheres can constitute a safety hazard.
