background image

1

IMPORTANT SAFETY INSTRUCTIONS

READ ALL INSTRUCTIONS BEFORE USING

WARNING

To prevent personal injury or property damage, do not attempt to start engine until all assembly
steps are complete and you have read and understand the safety and operating instructions in this
manual.

Under California law, and under laws of several other states, you are not permitted to operation
internal combustion’s engine using hydrocarbon fuels on any forest covered, brush covered, or
grass covered land, or on land with grain, hay, or other flammable agricultural crop, without an
engine spark arrester in continuous effective working order. The engine on your power equipment,
like most outdoor power equipment, is an internal combustion engine that burns gasoline, a
hydrocarbon fuel. Therefore, your power equipment must be quipped with a spark arrester muffler
in continuous effective working order. The spark arrester must be attached to the engine exhaust
system in such a manner that flames or heat from the system will not ignite flammable material.
Failure of the owner/operator of the equipment to comply with this regulation is a misdemeanor
under California law, and may also be a violation of other state and/or federal regulations, laws,
ordinances, or codes. Contact your local fire marshal or forest service for specific information
about what regulations apply in your area.

Wear approved safety glasses when operating this equipment. The operation of any powered
machine can result in foreign objects being thrown by high-speed rotating parts.

Wear work gloves, sturdy footwear, and hearing protection when operating this equipment.

Remove hearing protection and watch for traffic when operating near, or when crossing roadways.

Before inspecting or servicing any part of equipment, shut off engine, disconnect spark plug wire
from spark plug, and make sure that all moving parts have come to a complete stop. Be aware that
rotating blades slow down gradually after engine is shut off.

Exercise extreme caution on slopes and avoid excessively steep slopes.

Never leave equipment unattended when engine is running. Shut off engine and disconnect spark
plug wire from spark plug before leaving equipment. Turn off fuel shut-off if equipped.

Do not blow any burning or smoldering materials such as cigars, cigarettes, ashes, or cinders.

Do not blow areas that have been recently treated with fertilizers, pesticides, or herbicides. Follow
chemical manufacturer’s safety instructions regarding contact with treated areas.

Keep in mind that the operator or user is responsible for accidents or hazards occurring to other
people or their property.

Thoroughly inspect the areas where the equipment is going to be used, and remove all objects that
may be a hazard when thrown.

Never pick up or carry equipment while the engine is running.

Walk, never run.

Never allow children or untrained adults to operate this equipment.

Keep the area of operation clear of all persons, particularly small children, and pets. Keep bystanders
at least 25 feet away from the area of operation.

Содержание HT9608H













Отзывы: