Parker HLR Series, Инструкция по монтажу

Страница: 29 / 56

Parker EME Assembly of Z-axes
192-510201N1 HLR 2019-04
29
3.6.1. Mounting ETH/ETT032 on single axis via bracket plate
Figure 6: Mounting ETH/ETT032 via bracket plate

The HLR linear axis must be mounted in the system according to these mounting
instructions (see chapter mounting of an individual axis (see page 21)).

Remove both centering sleeves on the carriage of the linear actuator (please
refer to Figure 6: Pos. 5).
Carriage and bracket plate must be clean and free of grease.

Position the bracket plate so that the longitudinal grooves of the bracket plate are
above the mounting threads in the carriage. Depending on the size of the linear
axis, either the outer or inner longitudinal grooves should be used.

Fix the bracket plate with the screws supplied (see Figure 6: Pos. 1) on the
carriage. Position screws only slightly.

Adjust the desired excess of the bracket plate to the linear axis and crosswise
tighten the screws (see Figure 6: Pos. 1) to the respective tightening torque (see
Table 6).
For the following steps the ETH cylinder with attached motor/gear must be
present If this is not the case, mount the motor/gear package according to the
ETH assembly instructions.
When using the ETH cylinder with parallel guide, first remove the parallel guide
from the cylinder.
Secure the Z-axis + motor / gear against tilting or falling during the assembly
process.

Place the ETH/ETT cylinder on the cantilever plate in the centering bore
provided.

Fix the ETH/ETT cylinder crosswise with the screws supplied (see Figure 6: Pos.
4)and the required tightening torque (see Table 6).
When using the ETH cylinder with parallel guide, first place the parallel guide at
the bottom of the outrigger plate and fix the entire unit with the screws supplied.