Parker CT3000, Руководство оператора

Страница: 15 / 39

Section 7.0 – ROUTINE MAINTENANCE
Routine Maintenance
The air cooled condenser on your dryer must be kept clean. Inspect on a regular
basis for dirt or debris that might accumulate. Remove any debris immediately.
Although the filter on your dryer is connected to a drain timer it is recommended
that the drain and solenoid be checked weekly. The Y-strainer should be checked
monthly. (Fig. 4)
It is not advisable to tamper with the other adjustments unless you
are familiar with refrigeration. The controls interact with each other
and, although the effect of an adjustment may not be immediately
obvious, it will affect the dryer’s performance.
C C H H A A R R G G E E L L I I Q Q U U I I D D O O N N L L Y Y , , D D O O N N O O T T V V A A P P O O R R ! !
ƒ
ƒ
See tag for correct refrigerant charge.
See tag for correct refrigerant charge.
ƒ
ƒ
Unit needs to be pulled into vacuum 500 micron (minimum) Unit needs to be pulled into vacuum 500 micron (minimum)
ƒ
ƒ
The full charge might not be accepted. If this occurs, the unit
can be started and then the remainder of the charge should be
slowly metered into the suction side (Suction side is always the
inlet to compressor side).
The full charge might not be accepted. If this occurs, the unit
can be started and then the remainder of the charge should be
slowly metered into the suction side (Suction side is always the
inlet to compressor side).
ƒ
ƒ
The unit needs to maintain a suction pressure between 28…35
PSI with no air load. If the full charge has been applied and
suction pressure is too high, see Adjustments in Section 5.
The unit needs to maintain a suction pressure between 28…35
PSI with no air load. If the full charge has been applied and
suction pressure is too high, see Adjustments in Section 5.