Parker EME
Setting up Compax3
192-120103 N13 C3I20T11 / C3I32T11 December 2010
261
4.4.9.7
Overview of the user interface
In this chapter you can read about:
Selection of the signal or system to be measured. ......................................................... 261
Frequency settings ........................................................................................................ 265
Speed control ................................................................................................................ 266
Other settings ................................................................................................................ 269
Operating and status field .............................................................................................. 271
Display of the measurement result ................................................................................ 274
Display of the measurement point at the cursor position ................................................ 275
(1)
Selection of the signal or system to be measured
(see on page 261)
(2)
Frequency settings
(see on page 265)
(3)
Other settings
(see on page 269)
(4)
Operating and status field
(see on page 271)
(5)
Display of the measurement result
(see on page 274)
(6)
Display of the measurement point at the cursor position
(see on page 275)
Selection of the signal or system to be measured.
In this chapter you can read about:
Current control ............................................................................................................... 262
Mechanical system ........................................................................................................ 262
Position control .............................................................................................................. 264
With the aid of the tree structure, you may select what you want to measure. Here,
the selection is made, if a frequency spectrum or a frequency response is to be
measured.
The shown structures are simplified in such as all feedbacks are displayed without
special transmission behavior. This is surely not the case in reality, serves however
a better overview.
