Parker Airtek SMART CYCLE PLUS 80, Руководство оператора, Страница: 22 / 45

- 22 -
Section 8.0 – MAINTENANCE CHARTS
The maintenance chart below indicates the components that should be checked while performing routine
maintenance on the dryer. The chart also indicates how often a specific check should be done.
REFRIGERATED
SERIES MAINTENANCE SCHEDULE
TIME WEEKLY MONTHLY
BI-
ANNUALLY ANNUALLY
Coalescing Filter Element Check Replace
Condensing Coil (AC units) Check/Clean Check/Clean Check/Clean Check/Clean
Condenser (WC units) Check/Clean**
Drain Line Y-Strainer Check/Clean Check/Clean Check/Clean Check/Clean
High Pressure Switch Check Check Check
Low Pressure Switch* Check Check Check
Fan Control Switches (AC
units)
Check Check Check
Compressor Oil Level Check Check Check Check
Drain Solenoid Check/Clean Check/Clean Check/Clean
*The low pressure switch may require more frequent adjustments depending on the ambient conditions.
** The condenser should be cleaned only if the unit is running abnormally high discharge pressure. Contact
the factory for verification prior to proceeding with this maintenance item.
MAINTENANCE PROCEDURES
Before performing any maintenance on the machine ensure that air pressure is vented from the
system. Also make sure that personnel performing the maintenance have read the maintenance
section of the manual.
Some of the maintenance tasks will require the refrigeration system to run, but when not required,
turn the unit off before proceeding.
Upon completion of the maintenance tasks be sure that the machine has been properly reassembled
prior to restarting and reintroducing air.
ROUTINE MAINTENANCE
This section covers the various components that require periodic maintenance and/or replacement.
Coalescing Filter Element
The coalescing filter element should be check Bi-Annually. On units with the standard control panel, check
the pressure drop across the unit by using air pressure gauges upstream and downstream of the dryer using
the closest possible gauges to the dryer. If it is determined that there is a high pressure drop across the
machine, remove the filter element from the machine and inspect it. If the filter is dirty,
replace it. Ensure