GB - 7
DO NOT fill gasoline tank indoors, when
engine is running, or while engine is hot.
Allow engine to cool several minutes before
removing fuel cap.
Do not mix oil with gasoline.
DO NOT overfill. Allow about 1/2” (12 mm) of
tank space for fuel expansion.
Replace gasoline tank cap securely and
clean any spilled fuel before starting engine.
If fuel is spilled on clothing, change clothing
immediately.
NEVER store fuel inside where there is an
open flame, such as a water heater.
ALWAYS drain fuel outdoors away from
ignition sources.
ALWAYS shut off engine, and remove key,
and close fuel shutoff valve when transporting
unit on a truck or trailer.
MAINTENANCE AND STORAGE
Keep all nuts, bolts, and screws tight to be
sure the equipment is in safe working
condition.
Never store equipment with fuel in the tank
inside a building where fumes may reach an
open flame or spark.
Allow engine to cool before storing in any
enclosure.
To reduce the fire hazard, keep the engine,
silencer, battery compartment, and fuel
storage area free of grass, leaves, or
excessive grease.
Replace worn or damaged parts for safety.
The VAC 35 covered in this owner's guide is
shipped complete in one box. Follow all
instructions on assembly very carefully.
Carton Contents
•
Unit
•
Literature Pack
•
Spin-Pak
®
Deflector
ASSEMBLY
1. Remove all items from carton.
2. Tip box over so wheels are toward floor.
Pull unit out of box and stand upright.
IMPORTANT:
DO NOT discard the carton or
any of the inserts until the unit is completely
assembled.
3. All hardware is on the unit in its proper
location. If something is missing, notify
the dealer/distributor where unit was
purchased. If unable to purchase parts
locally, contact Parker.
HANDLE ASSEMBLY
1. Remove the four 1/4-20 hex bolts and
hex lock nuts from the bottom end of the
upper handles and place upper handles
over the ends of the lower handles.
2. Align the mounting holes in upper and
lower handles. Replace 1/4-20 hex bolts
in the bottom two mounting holes.
3. Lift handles until the back braces can be
installed on the hex bolts installed in
step 2. Loosely install 1/4-20 hex lock
nuts.
4. Align the upper holes in both upper and
lower handles. Install the two 1/4-20 hex
bolts and hex lock nuts. Do not tighten.
5. Align the crossbar with the mounting
holes at the top of the upper handles
and install with two 1/4-20 hex bolts and
hex lock nuts. See Figure 4.
ASSEMBLY
WARNING:
AVOID INJURY. Read
and understand the entire
Safety
section before proceeding.
Figure 3
1/4-20 Hex Bolts and
Hex Lock Nuts