Parker 892 Series, Руководство пользователя

Страница: 12 / 32

Bulletin HY25-1890-M1/US
Owner’s Manual
10-Bolt Extended Shaft PTOs
Parker Hannifin Corporation
Chelsea Products Division
Olive Branch, MS 38654 USA
8
PTO Pre Installation
Installation Instructions
1. At installation, the input housing is installed to the
transmission first. The 890/897 comes from the
factory assembled. Remove the 4 bolts that connect
the tube section to the input housing (
Fig. 1 ).
2. Split the input from the output tube assembly. It will
be tight because of the installed O-Ring seal.
O-Ring must be installed into the O-Ring groove on
the tube pilot shoulder (
Fig. 2 ).
NOTe : If O-Ring is damaged, replace it with the one
supplied with the PTO Unit.
3. Install the fitting (1) into the pressure port on the
valve cap as shown
Fig. 3 . Torque to 156-180 lbs-in
[18-20 Nm]. Next install the pressure switch
(890 Series Only) (2) into the port in the valve cap
as shown and torque to 120-140 lbs-in [14-16 Nm]
(
Fig. 3 , 3a , & 3b ).
NOTe: See Hose Installation Sketch SK-504
(890/892 Series) on page 20 or SK492/SK-599 (897/899
Series) on page 21 .
Fig. 1
Fig. 2
Fig. 3
Fig. 3b After 02/22/16 Fig. 3a Prior to 02/19/2016
890/892 Series
(1)
(2)
897/899 Series
(1)
897/899 Series
(1)