Parker 890 Series, Быстрый старт

Страница: 19 / 30

Page 18
Running in Local
•
On the keypad select LOCAL mode. The display will show the Local Setpoint : 0.0%
•
Use the UP arrow to set a Local Setpoint, say 20%.
•
Press the green RUN button. The motor will accelerate to the desired speed and maintain it. Adjust
RAMP ACCEL TIME in Quick Setup to the desired level.
•
Press the red STOP button. The motor will decelerate to a stop. Adjust RAMP DECEL TIME in
Quick Setup to desired level. If the drive trips on Overvoltage, extend the RAMP DECEL TIME or
connect a braking resistor. Refer to the 890 Engineering Reference Manual.
Go to SYSTEM::SAVE CONFIG::APPLICATION and UP arrow to save your settings Values are
stored during power-down.
Running in Remote
•
On the keypad select REMOTE mode. The display will show the remote Setpoint : ?.?% (The value
displayed depends on the external speed reference).
•
Dial in a speed setpoint using the Speed potentiometer until the display reads 20%.
•
Start the drive by closing the Start contact between terminal X14/03 and terminal X15/02. The
motor will accelerate to the desired speed and maintain it. Adjust RAMP ACCEL TIME in Quick
Setup to the desired level.
•
Open the Start contact. The motor will decelerate to a stop. Adjust RAMP DECEL TIME in Quick
Setup to desired level. If the drive trips on Overvoltage, extend the RAMP DECEL TIME or connect
a braking resistor. Refer to the 890 Engineering Reference Manual.
Go to SYSTEM::SAVE CONFIG::APPLICATION and UP arrow to save your settings Values are
stored during power-down.
SAVE CONFIG
M

for example
M
"UP" TO CONFIRM
PROG
SETPOINT REMOTE
0.0 %
=
PROG
(NORMAL ACTION OF PROG KEY)
DISPLAYS OPERATOR MENU
SAVE CONFIG
menu at level 2
SAVE CONFIG
APPLICATION
SAVE CONFIG
SAVE CONFIG SAVE CONFIG
menu at level 2