Parish Cheetah DC2000, Руководство пользователя, Страница: 4 / 13

Operation of High Speed Floor Machine
* THIS IS A SPECIALIZED MACHINE WHICH
REQUIRES THE OPERATOR TO UTILIZE A
TRIPLE S
APPROVED PAD, AND MUST BE
ADJUSTED PROPERLY TO ENSURE THE
HIGHEST POSSIBLE PERFORMANCE
AND PRODUCTIVITY.
* Read operators manual thoroughly prior
to operating or servicing this machine.
GENERAL USE
1] Remove any obstructions or other
obstacles in the area which is to be
cleaned.
2] Remove dust recovery bag and empty it out
in a trash receptacle. Replace dust
recovery bag on machine, ensuring it is
sealed tightly to the machine.
3] Place handle in upright position and tilt
machine back until handle rests on the
floor.
* Be sure the machine is not plugged into
an outlet.
4]
Remove the pad center gripping device by
unscrewing the thumbscrews.
5]
Place a "
Triple S
approved" burnishing pad
on the pad driver and re-attach the
center gripping device. (check with your
local
distributor for approved pads)
6]
Place machine back into its upright position.
7]
Plug power cord into grounded outlet.
* Do not use an extension cord in
conjunction with the standard power cord.
8] The handle height may be adjusted by
lifting up on the handle release lever,
located on the right side of the switch
housing. Pull trigger and lower handle
to desired operating position. Release
trigger to lock handle into place.
9] To start the machine, push on the red
safety release button located on the top
of the switch housing and squeeze either
switch lever.
10 ] Once the machine has reached operating
speed, look at the digital pad pressure
meter located on the top of the motor cover.
There are 3 light colors which will help you
determine optimal pad pressure for
operating the machine. RED LIGHT(S): If
one or both red lights are illuminated, stop
the machine and turn the pad pressure
-4-