Parata Systems AccuCount II, Руководство пользователя

Страница: 77 / 150

120-0313 Rev 04 4–23
Chapter 4 – Customization
Each of the 24 positions in a Header or Footer may be assigned one of the options
shown in Table 4-18 (if applicable).
All positions OFF To set all of the positions in the Header or Footer to Off :
1 Press the Enter soft key to select Set .
The scale displays the Set all Positions off? prompt.
2 Press the Yes soft key to confirm the reset;
or press the Cancel soft key to back out.
Set default settings To restore the factory default settings for all positions in
the Header or Footer:
1
Press the Enter soft key to select Set .
CAUTION The scale immediately restores the default settings,
without prompting you to confirm!
Table 4-18: Protocol - Header/Footer - Position option definitions and applicability
Option Header? Footer? Function
Off Yes Yes Position not used (i.e., no output).
Application Yes No Outputs the running application.
Device type Yes No Outputs the device type (i.e., the name of the
scale).
Device ID Yes No Outputs the device identifier (see “Device
settings” on page 4-25).
Device number Yes No Outputs the device number (i.e., the model
number of the scale).
Device firmware Yes No Outputs the device software version number
(e.g.,
A00-0012 P02
).
Date/Time Yes Yes Outputs the current date and time
(see “Date/Time” on page 4-27).
User Yes Yes Outputs the user identifier (see
“Administrator submenu” on page 4-2).
Table 4-17: Protocol - Header/Footer - Position settings and procedures (cont’d)
Setting Function