Parasound Zamp v.3, Руководство пользователя

Страница: 10 / 14

No sound
- Check that AC is live.
- Check that input cables and speaker wires are secure at both ends.
- Make sure the control preamp/receiver is switched to the correct input.
- Is the unit on? Check setting of the Turn On Options switch.
- Is the Hi-Temp or Protect (or both) illuminated? Check for excessive temperature, short circuit-
ed speaker wires, low impedance speaker load, and inadequate ventilation to remove heat.
Background Hum
- Move audio cables and AC cords away from each other.
- Try different routes for the audio cables and AC cords.
- Make sure insulating shoulder washers are used if unit is rack mounted.
- Make sure all of your components are plugged into the same AC outlet.
Distorted and Weak Sound
- Check the position of the Bridged Mono-Stereo switch. It must be in Stereo to play stereo.
- Make sure the load impedance is not below 4 ohms.
- Make sure the gain of the preamp or controller is not set too low.
- Make sure the gain controls of the Zamp v.3 are not set too low.
TYPICAL PROBLEMS AND REMEDIES
8