Parasound Halo JC 5, Руководство пользователя

Страница: 8 / 20

8
Rack Mounting Your Parasound JC 5
To mount the JC 5 into a 19" wide equipment rack, you must first attach its two “L” shaped rack mount
brackets (included). With its four feet removed, the JC 5 chassis and front panel height occupies four rack
spaces (7" or 176 mm). When mounting equipment below the JC 5, you will also need to allow about 1 8"
below the unit for the bottom chassis screws.
To attach the rack mount brackets:
• Remove the three screws from each side of the JC 5. These are arranged vertically, behind its front panel
and in front of its first heatsink fin.
• Line up the three holes on each bracket with the three holes on the JC 5 and reinsert the screws.
• Make sure the screws are tight because they will support the entire weight of the JC 5 in the equipment rack.
Note: Tighten each bolt just enough to keep the unit secure in the rack to avoid deforming the shoulder
washers. Eliminating metal-to-metal contact reduces the likelihood of creating a ground loop that might
introduce hum into your system.
A single standard rack space is 1-3 4" (44mm) high in a 19" wide equipment rack. This measurement
standard was developed by the EIA (Electronic Industries Association) so manufacturers of electronic
components and equipment racks could build products in standardized heights that would fit in a uniform
space. Please call your Parasound dealer or Parasound Technical Services if you need additional advice
about rack mounting the JC 5. Keep the above Note and Warning