12
WATER VALVE INSTRUCTIONS
(CONT.)
must be aligned over the half of the base that has only one
port (Figure 5).
4. Set the module in the base and rotate slightly back and forth until
the alignment pins on the bottom of the module drop into the
alignment holes in the base (Figure 3).
5. The module should fit in the base without forcing it. If it does not
seat easily then check the following.
• (Figure 3) shows the piston portion of the current module
design (released 06-2011). These pistons are set at the
factory. Do not touch, pull or turn these pistons. Any han-
dling will negatively affect the performance and fit of this
product.
• If the flow optimizer (Figure 4) prevents the module from
seating properly in the base you may have to remove it.
To remove optimizer press in on the 3 clips and pull to
seperate.
