Paramount Fitness KLD7003S, Руководство пользователя

Страница: 12 / 16

12 - -
Lighting
:
1.Turn the control knob to “OFF” position.
2.Slowly open the gas cylinder valve.
3.Press and turn the control knob to “HIGH” position (counterclockwise).
Flame ignites after click sound.
4.If burner does not light immediately press and turn control knob to “OFF”
Position and try again from start. Allow 30 seconds between ignition
attempts for gas to dissipate. Several attempts may be necessary.
5.With the burner alight keep control knob depressed for 15 seconds.
6.For mininum heat push in and turn the control knob counterclockwise
to “LOW”
NOTE: If burner fails to remain lit, all valves should be closed and a
waiting period of at least 5 minutes should pass before attempting to light.
WARNING: FOR YOUR SAFETY: If at any time you are unable to light the
burner and smell gas, wait 5 minutes to allow gas to dissipate before
attempting to light heater. If after 1 minute, you are unable to light
burner, wait 5 minutes and allow flammable vapors to dissipate before attempting to light heater again.
NOTE:
If a new tank has just been connected, please allow at least one minute or more for the air in the gas line to
purge out through the hole, or simply complete Step 3. When lighting the heater make sure that the control knob is
continuously depressed while pressing the igniter button. Control knob can be released after the flame has been lit for
20~30 seconds. Flame can be watched and checked from the peephole located on the base of burner. If the flame does
not light or it goes out, repeat Step 3. If the burner flame goes out accidentally or it is blown out by wind, turn off the
heater and wait at least 5 minutes or more to let the gas dissipate before relighting to avoid possible gas explosion.
Repeat steps as listed above.
TO TURN OFF THE HEATER
1. Press and turn the control knob clockwise to “OFF” position.
2. Turn the gas cylinder valve to OFF or closed and disconnect the cylinder.
If you experience any ignition problems, please consult “Troubleshooting” on page 15.
Caution : Avoid inhaling fumes emitted from the heater’ s first use. Smoke and odor from the burning of oils used in the manufacturing will
appear. Both smoke and odor will dissipate after approximately 30 minutes. The heater should NOT produce thick black smoke.
When Heater is ON
:
Emitter screen will become bright red due to intense heat. The color is more visible at night. Burner will display
tongues of blue and yellow flame. These flames should not be yellow or produce thick black smoke, indicating an
obstruction of airflow through the burners. The flame should be blue with straight yellow tops. If excessive yellow
flame is detected, turn off heater and consult “Troubleshooting” on page 15.
Re -Lighting
:
Note : For your safety, control knob cannot be turned OFF without first depressing the control knob and then
rotating to OFF.
1. Turn control knob to “OFF” position.
2. Wait at least 5 minutes to allow gas to dissipate before re-lighting.
3. Repeat the “Lighting” steps as listed above.
OPERATING INSTRUCTIONS