Paramount Fitness FPT1524, Инструкция по эксплуатации

Страница: 8 / 21

8
ASSEMBLY INSTRUCTIONS
1
.
NOTE: It is best to use TWO PEOPlE for assembly of this
gas fire pit. Locate 4 legs -F . Screw 2 Studs -M into the
holes on each side of the leg. Make sure all legs have the
foot end facing down, then align holes in 3 Side Panels -D
with ends of the Studs -M sticking out of each leg. Attach
the Side Panel to the leg using Washer/Spring Washer/
Nut -O / P / Q . Tighten loosely with Wrench -S . (DO NOT
OVERTIGHTEN as you will need to adjust panels to
ensure proper alignment.) Once all Side Panels are
loosely attached to the legs, align the Door Panel -E with
the Studs sticking out of the legs and attach the Door
Panel using Washer/Spring Washer/Nut -O / P / Q with
Wrench. Once all Panels are attached to the legs, tighten
nuts with Wrench.
2
.
Once Side Panels/Door Panel/legs have been secured,
attach Gas Tank Support bar -G to legs by aligning holes
in Gas Tank Support bar with holes in legs. Insert bolt -N
through Washer -O and then into holes and tighten with
Allen Wrench -T . Then place end of Gas Tank Support
Ring -H over Gas Tank bar and align front of Gas Tank
Support Ring with holes in Door Panel -E . NOTE: There
are two holes on the leg. Use the lower hole as shown in 2
to attach the Support Ring. Insert bolt -N through Washer
-O and then through hole. Tighten with Allen Wrench.
E
D
D
D
Use lower
hole on leg
Hardware Used
M
O
P
Q
S
Hardware Used
Bolt
（
6*18mm
）
Spring Washer(M6)
Allen Wrench
X 5
X 5
X 1
N
O
T
8
ASSEMBLY INSTRUCTIONS
1
2