Paramount Fitness FP-452, Инструкция по эксплуатации

Страница: 5 / 11

ASSEMBLY INSTRUCTIONS
1
.
NOTE: It is best to use TWO PEOP
/
E for assembly of this
gas fire pit.
Assemble the fire pit base: Locate Door Panel
D, three Side Panels E
/F
Door Frame Leg
G
, and 2
Support Legs
H
.Screw Studs O into the holes in the sides
of all four legs, including the leg pre-assembled to the
door. In the order shown in the illustration, beginning with
Door Frame Leg F , join the legs and panels together by
fitting the holes on the sides of the Side Panels onto the
Studs installed earlier.To secure the Legs to the Panels,
place a Washer Q then a Spring Washer R onto each
Stud, then thread a Nut S onto each Stud. Do not tighten
the hardware until the entire base is assembled. Then,
firmly tighten all Nuts with the Wrench V, but DO NOT
OVERTIGHTEN.
Hardware Used
O
Q
R
S
V
ASSEMBLY INSTRUCTIONS
1
X 1
X 1
X 1
X 1
X 1
O
SRQ QRS
O
Attach Tank Support Ring J to Tank Support Bar I by
aligning holes in the center of Tank Support Bar with holes
in the end of Tank Support Ring. Insert Bolt P through
Washer Q and then into holes. Tighten with Allen Wrench
W.
2
.
2
Hardware Used
Bolt
（
6 *
16
mm
）
Washer(M6)
Allen Wrench
X
X
X 1
P
Q
W
P
Q
F
E
D
G
H
H
E