Page 17
Main Power Switch
Operating with Touch Panel
Once the appliance has been plugged into a grounded electrical outlet, it is ready to operate.
NOTE: Ensure the house circuit breakers for the power supply are turned on. In the event of a power
failure, the appliance will lose its memory function and will reset to factory mode when the power
returns.
To turn unit power on:
1. Plug in power cord.
2. Turn on the power switch (located on the front bottom right side of the appliance).
3. Verify the power is turned on when two ring tones are initiated.
The unit can be controlled by either the touch panel controls which are located on the right side of the front
glass or the remote control.
1. Press “
” to turn on and off the appliance.
2. Press “
” multiple times to adjust between mid, low, on/off, or high brightness options
3. Press “
” multiple times to set operating duration to 30 min, 1h, 2h, 3h, 4h, 5h, 6h, 7h, 8h, or off.
4. Press “
” key: set the required room temperature, the parameters is pre-set in degrees Celsius
Note: The touch panel buttons will glow when pressed. The light fades in 5 seconds after pressing.
Operating Instructions
WHILE THE APPLIANCE IS OPERATING DO NOT REMOVE THE GLASS PANEL. THIS WILL CAUSE THE
REMOTE CONTROL AND TOUCH PANEL TO DISFUNCTION.
WARNING
ON/OFF
Power
Flame
Timer
Heater
Indicator
01.18.19
18-19-20-21-22-23-24-25-26-27-28-OFF (indicate t0); Repeat circulation. key for 5 seconds,
hear a “beep” sound once, the indication switches to Fahrenheit degree; the parameter is set to
Fahrenheit degree of 64-66-68-70-72-73-75-77-79-81-82-OFF (indicate t0) Repeat circulation.
"
Press “
;
;
;
