7.
Installation Procedures
This device may be used on a desk-top or it can be installed in a 19” rack enclosure. Before
installation into a rack enclosure, the 2 x L-Shaped brackets from the kit pack should be fitted
to the sides of the unit as shown in the illustration below.
Once the brackets are securely fitted, the unit should be positioned so that the mounting
holes in the brackets are aligned to the rack holes. The unit should then be secured using
captive fixings, to ensure the device is secured in the rack assembly. Note – if you are using
the rear GND terminal, then you may have to attach your Ground Cable before installing the
unit into the rack, depending upon whether or not your rack has an open rear access panel
or door.
