Copyright © Parallax Inc.
WIZnet W5200 for QuickStart (#40002)
v1.0 3/13/2013 Page 4 of 10
Typical Home Network Configuration
Most home networks are configured like this:
Attach your Quic W5200 board to your home wireless router as a wired Ethernet device.
Connections
Only a few connections are required to get your Quic WIZnet W5200 board talking over Ethernet.
1.
Once you have secured the W5200 board to your QuickStart board, connect a CAT 5 or greater
Ethernet cable to the RJ-45 Ethernet jack on the left.
2.
Attach the other end of the Ethernet cable to your home router, Ethernet switch, or other
Ethernet device – as noted in the “Typical Home Network Configuration” section.
3.
Next, power the system with one of the options, below.
That’s it!
Power Supply Options
The Quic WIZnet W5200 may be powered by any of these three options; it is safe to connect any
combination of these at the same time:
USB power via the Propeller QuickStart
6–9 VDC via 2.1 mm center-positive barrel jack
Power over Ethernet with Silvertel Ag9050 daughter board (see page 6 for details).
Internet
Home Wireless Router
(Gateway to Internet)
Wired Ethernet
Devices
WiFi Devices
Cable, DSL, or
Dial-up MODEM
