Paragon TnF 2 Скачать руководство пользователя страница 2

If you use an existing ½” hole, first insert the porcelain insu-

lator on the thermocouple. Then insert the thermocouple into

the hole. The thermocouple must protrude into the firing

chamber at least ½” to 5/8”.

IMPORTANT! If the thermocouple falls out of the kiln dur-

ing firing or if the tip moves out of the firing chamber, the

kiln will over-fire. Monitor the kiln during firing to make

sure the thermocouple has not moved.

Drilling a 1/8” Thermocouple Hole

1

2

Wearing safety glasses, drill a 1/8" hole all the way through

the kiln case and wall.

3

Enlarge the 1/8” hole in

the kiln case to 1/4". Using a

¼” drill bit, drill just deep

enough to go through the

case and no further. En-

larging the hole in the kiln

case to 1/4" will prevent the

thermocouple from touching

the grounded steel case.

4

Press the thermocouple

into the hole so that ½” to

5/8" or more of the tip pro-

trudes into the firing cham-

ber.

REMINDER: If the thermocouple is pulled out of the hole,

the kiln will overfire.

5

Position the thermocouple lead wires so they are away from

the hot sides of the kiln case, the cord set, or any other electri-

cal appliances or wiring.

Step 3: Plug the kiln into the

receptacle on the TnF 2.
Step 4: Plug the TnF 2 into

the wall receptacle.

Plug your TnF 2 into the wall receptacle your kiln was us-

ing. Do NOT change the TnF 2 plug if it won’t fit the wall re-

ceptacle.

Step 5: Turn the kiln switches

to High.

Turn all kiln switches to the On or High position. Leave all

switches on full power when firing with the TnF 2.

If kiln does not have a Kiln Sitter, the installation is com-

plete. Read the controller instruction manual before firing.

Step 6: Insert a cone in Kiln

Sitter, set Limit Timer.

1

If your kiln has a Kiln Sitter® or Limit Timer, use it as a

back up shut-off for the TnF 2. Place a cone in the Kiln Sitter

rated one or two cones hotter than the firing. Set the Limit

Timer for a few minutes

longer than the expected fir-

ing time.

It will be necessary to use

a new cone for every firing

even if the previous cone

did not bend.

WARNING: We cannot extend our

warranty to cover any damage caused

by overfiring, regardless of the

circumstances. Even though your TnF

2 is an automatic controller, do not

leave your kiln unattended while

firing.
Wear firing safety glasses when

looking into the peephole during

firing.

Отзывы: