IMPORTANT SAFEGUARDS
READ ALL INSTRUCTIONS BEFORE USING
Caution and proper procedures must be practiced at all times when using
electrical appliances. When using electrical appliances, basic safety
precautions should always be followed, including the following:
Do not use appliance for other than intended use.
Do not touch hot surfaces. Use handles or knobs.
To protect against electrical shock, do not immerse cord, plugs, or appliance
in water or other liquid.
Unplug from outlet when not in use and before cleaning. Allow to cool before
putting on or taking off parts.
Do not operate any appliance with a damaged cord or plug or after the
appliance malfunctions or has been damaged in any manner. No user
serviceable parts inside. Return appliance to the nearest authorized service
facility or call our toll-free customer service number 1-888-731-6688 for
information on examination, repair, or adjustment.
The use of accessories and/or attachments not recommended or sold by the
appliance manufacturer may cause injuries.
Do not use outdoors. This appliance is intended for indoor use only.
Do not let cord hang over edge of table or counter, or touch hot surfaces.
Close supervision is necessary when any appliance is used by or near
children.
Do not leave the appliance unattended when switched on.
Extreme caution must be used when moving an appliance containing hot
liquids.
If the supply cord is damaged, it must be replaced by manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
The appliance is not intended to be operated by means of an external timer
or separate remote-control system.
The temperature of accessible surfaces may be high when the appliance is
operating.
If using an extension cord, the marked electrical rating of the extension cord
should be at least as great as the electrical rating of the appliance.
UNPACKING
BE SURE TO REMOVE ALL PACKING MATERIAL BEFORE USE.
OPERATING INSTRUCTIONS
Place the unit on a well ventilated flat, sturdy surface away from heat
sources.
This product should not be used in the immediate vicinity of water,
such as bath tub, washbowls, swimming pool etc. where the likelihood of
immersion may occur.
Plug cord into a rating 120V AC power outlet
Remove the wire basket and set aside.
PREPARATION
1.
Run towels briefly under water.
2.
Wring out excess water from the towels. Towels should be damp, not
soaked. You may need to wring out several times.
3.
Fold or roll towel and place towels in the wire basket. Do not overload the
wire basket or directly place towels into the towel warmer.
4.
Insert the basket and towels into the towel warmer
5.
Close the door firmly.
6.
Turn on the power switch. The power switch lamp will remain illuminated
while the switch is in the
“ON” position.
CLEANING & MAINTENANCE
Maintenance should be performed after each day’s use.
1.
Turn OFF the unit by using the power switch.
2.
Unplug the cord from the power outlet.
3.
Wait for contents to cool before handling. Contents may be hot. Remove the
wire basket and towels. Set the wire basket aside to dry.
4.
With a soft cloth, wipe down the internal surfaces. Do not use harsh
chemicals or abrasives. To clean the exterior, use a soft cloth and mild soap.
5.
Pull the drip tray forward and empty contents. Set the drip try aside to dry.
TROUBLESHOOTING
There is excessive moisture when the towel warmer is ON.
The towels are heating up very slowly.
Check to see that the towels are only slightly damp. Excess moisture
and/or slow heating time may be a result of soaked towels.
The door is not closing properly and/or steam is escaping.
Check that the silicone door seal is in place. Push into door groove to
assure proper fit.
C A U T I O N
INTERNAL SURFACES, WIRE BASKETS, TOWELS AND STEAM MAY
BE HOT. USE EXTREME CAUTION WHEN REMOVING HOT TOWELS
OR BASKETS. ALWAYS USE PROTECTIVE HEAT RESISTANT
GLOVES OR MITTS TO AVOID STEAM OR OTHER BURNS. FAILURE
TO HEED WARNINGS MAY RESULT IN HARM OR SERIOUS INJURY.
W A R N I N G
TO PREVENT ELECTRICAL SHOCK, UNPLUG BEFORE CLEANING.
C A U T I O N
TO AVOID ELECTRICAL SHOCK, DO NOT IMMERSE IN WATER.
C A U T I O N
TO REDUCE THE RISK OF ELECTRICAL SHOCK, DO NOT OPEN
COVERS. NO USER SERVICEABLE PARTS INSIDE. REFER
SERVICING TO QUALIFIED SERVICE PERSONNEL.