Paragon FOCUS HE SLIMLINE SC, Руководство пользователя

Страница: 17 / 28

17
LT5316 (iss 5) 10/10
TENSIONING NUT
CLAMP SCREW
260mmCRS.
30mm
460mm
FIX 4 OFF EYE
IN POSITIONS
SHOWN
FOCUS HE SLIMLINE SC
Installation Instructions
SECTION NINE To Install the Appliance continued
FIXING FIRE INTO OPENING
NOTE: -Remove the glass panel and put safely to one side. Do not replace until installation is completed.

Mark the position of flange holes required in the fireplace front, drill and insert wall plugs

Remove the paper back from the length of seal and stick it around the rear of the front flange of the fire.
NOTE: -The seal must be positioned to ensure an airtight seal when the appliance is fitted.

Fix the fire box in position with wood screws.
CHECKING GAS SOUNDNESS

Turn on the gas supply to the appliance and check for soundness in accordance with current codes of practice.

Turn off the gas supply at the external Isolation valve.

Remove the pressure test point screw from the inlet elbow and connect the pressure gauge.

Turn on the gas to the appliance at the Isolation valve.

Push down on the lever

Check that the electrode is sparking at the gap between the thermocouple tip and the electrode; continue until pilot
ignition is established.

Lift the lever to the high rate position.

Check the inlet pressure is 20mbar. +/- 1.0.

Turn off gas supply, at the isolation valve. Disconnect the pressure gauge and replace the pressure test point screw.

Turn on the supply to the appliance and check the pressure test point for soundness with detection fluid.
OPTIONAL CABLE FIXING SYSTEM
Using a No 14 masonry bit drill four holes in the rear wall within the
range shown, fit rawl plugs provided and screw eyebolts securely into
plugs.

Remove paper back from length of seal around the rear flange of
the fire.
NOTE: -The seal must be positioned to ensure an airtight seal
when the appliance is fitted.

Position the fire close to fireplace, allowing sufficient access to
thread the cable through the eyebolts. Feed the cables (one cable
to each side) through the top holes in the firebox, through the
eyebolts, and back through the bottom holes in the firebox as
shown.

Push firebox fully back in the fireplace opening, allowing it to seal
against it to seal against the surround.

Feed the cables through the adjusters and cable clamps and slide
the clamps up the adjusters. Pull the cable as tight as possible
and tighten the cable clamps. With a spanner tighten up the
adjuster nut to tension the cable and make good the seal.
Note: - After fitting neatly coil up the excess cable. Do not cut
off the excess cable.