Instruction manual radio controlled alarm clocks
1808 EN
Features
- Time display in 12-/24-hour format
- Daily alarm with alarm repeat function
- Calendar
- DST function (summer time)
- Thermometer with °C/°F format for selection
- LED backlight
Function keys
- AL. ON/OFF (On/Off)
- SET
- RESET
- + = upwards
- = downwards
- SNOOZE/LIGHT (snooze/light knob)
Instruction
Initial display: hour, minute, second, weekday, date (day and month), temperature
Commissioning
Open the battery compartment and insert two new alkaline batteries (type Mignon 1.5 V). Radio reception will start
immediately. After 3 to 4 minutes, the watch receives the signal and adjusts itself correctly. If the signal is too weak and the
watch is unable to receive correct time information, reception will be canceled. Another transmission attempt will then be
initiated automatically every two hours. If the watch still does not receive a sufficient signal, try to find a better location (near a
window or turn the watch in 45 degree increments) and remove the batteries, wait one minute, and reinsert the batteries. Radio
reception will resume.
Improvement of radio reception
Place the watch in a location where it will not be exposed to any electrical interference or shielding. Avoid placing the watch
near a television or computer. Reception is best at night, when many sources of interference are inactive.
Manual time setting
1.
Press and hold the SET knob for 2 seconds to enter the time setting mode. The display blinks.
The display changes one by one: Time zone > Year > Month > Date > Hour > Minute > Language > °C/°F > Normal
position
2.
The setting is made using the "+" or "-" knobs, then press the SET knob to confirm the data.
12/24 Hour display
By briefly pressing the SET knob, you can switch between 12 (AM/PM) and 24-hour displays.
Alarm Time Setting
1.
Press the "+" or "-" keys in the initial display to display the alarm time.
2.
Press the keys "+" or "-" to set the desired alarm time.
3.
If no knob is pressed for 8 seconds, the alarm time is stored and the default setting is displayed again.
*Move the "On/Off" knob to the desired position to turn the Alarm & Snooze function on or off.
When the alarm is activated, the bell symbol appears on the display.
