OPENING THE SAFE FOR THE FIRST TIME
Open the emergency lock cover, insert the key and turn counter-clockwise until it stops. Next turn the handle clockwise to open
the safe.
INSTALLING BATTERIES
Open the battery compartment cover located on the inside cover of the door. Install the batteries as shown on diagram (4 AA
batteries). Close the battery compartment cover.
SETTING AND CHANGING PERSONAL CODE
1. Open the door and press the red button at the rear of the door. The yellow light will flash.
2. Set a personal code, input a 3-6 digit set of numbers.
3. Press “A” or “B” to confirm.
The yellow light will turn off, indicating the code was entered successfully.
Use the same procedure to change the code.
4. Test your code before closing the door.
USING YOUR PERSONAL CODE TO OPEN THE SAFE
Input your 3-6 digit personal code then press “A” or “B” to confirm. When the green light flashes, turn the handle clockwise to
open the safe.
WRONG CODE PROTECTION
If you input a wrong code, the safe will not open. If 3 consecutive incorrect codes are entered, the keypad will lock for
20 seconds. If another 3 consecutive incorrect codes are entered, the system will lock for 5 minutes. Operation can resume after
the 5 minute period.
EMERGENCY SYSTEM
If you forget your code or the batteries expire, you can use the emergency override key to open the safe. Open the emergency
lock cover, insert the override key and turn counter-clockwise to the end. Turn the handle clockwise to open the safe.
LOW VOLTAGE
If, when you open the safe the red light is flashing, this indicates the system is in low voltage. Replace the expired batteries with
fresh AA alkaline batteries.
DIRECTION FOR USE
7806 ParaGuard
Elite Heavy Duty Safe
Copyright © Paragon Lock and Safe. All rights reserved.
