Form 14-11-00-00 version 10
© 20
19
Paragon Pro Manufacturing Solutions All Rights Reserved.
2d) If ladder lock spring pins do not readily engage,
raise the cable between the sheaves slightly and jog
the telescoping ladder section to help facilitate complete
engagement.
DO NOT
pound on the lock pins.
Operation
continued
WARNING:
-
ALWAYS
make sure
ALL FOUR
ladder lock spring
pins are fully engaged before climbing.
-
NEVER
make height adjustments while a worker is
on the work platform. (see warnings, page
1-2
.)
WARNING:
While operating the Tele-Tower
®
Adjustable Work
Platform,
ALWAYS
keep the cable taut under the
telescoping ladder sheaves.
NEVER
rotate the winch
handle counterclockwise while the ladder lock pins
are engaged. Doing so will allow the cable to go
slack, which can cause the cable to wind unevenly on
the winch tube. This will cause the two telescoping
ladders to move unevenly in relation to each other,
binding up in the telescoping frame, and will hinder
proper and safe locking of the ladder lock spring pins.
- 9 -
3a) TO LOWER DECK:
—Be sure the cable passing under the telescoping lad-
der sheaves is taut and that the cable is wound evenly
at both ends of the winch tube.
3b)
—Retract and rotate the ladder lock spring pins to the
disengaged position.
—Rotate the winch handle counterclockwise.
Storing the cable:
Leave one end attached (as when in operation),
-Wind loose end around spools A-B and place spring
tube on hook C
-Detach other end and wind in similiar reverse pattern.
-Take up slack by rotating winch clockwise.
A
B
C