PARAGON OUTDOOR OH-R744S, Руководство пользователя, Страница: 15 / 19

CARE AND MAINTENANCE
OPERATION INSTRUCTIONS
Note:
After use, some discoloration of the emitter screen is normal.
Operation Checklist
For a safe and pleasurable heating experience, perform this check before each use.
Before Operating:
1. I am familiar with entire owner’s manual and understand all precautions noted.
2. All components are properly assembled, intact and operable.
3. No alterations have been made.
4. All gas connections are secure and do not leak.
5. Wind velocity is below 10 mph.
6. Unit will operate at reduced efficiency below 40°F.
7. Heater is outdoors (outside any enclosure).
8. There is adequate fresh air ventilation.
WARNING
FOR YOUR SAFETY
Heater will be hot after use. Handle with extreme care.
15
2.Disconnect the regulator from the cylinder following the instructions that came with your regulator.
3.Replace the cylinder.
4.In the absence of any flame, remove the plug or seal cap from the cylinder valve.
5.Check for the presence and good state of the gasket before connecting the regulator.
6.Check that the regulator seal is correctly fitted and able to fulfil its function.
7.Perform leak test using soapy water solution.
WARNING
FOR YOUR SAFETY:
• Do NOT touch or move heater for at least 45 minutes after use.
• Reflector is hot to the touch.
• Allow reflector to cool before touching.
REPLACING THE GAS CYLINDER
1.Close the valve of the gas cylinder.
Re-lighting:
Repeat the “Lighting” steps on prior page. 3.
happen if performed before 5 minutes are up .
Wait at least 5 minutes, to let gas dissipate, before attempti ng to relight POWER. Flash out will 2.
Press POWER button again to enter into close status 1.
WARN I NG
1.Change the gas cylinder in a amply ventilated area,
away from any ignition source (candle, cigarettes, other
flame producing appliances, ...)
2.Make sure that all taps on the consuming appliance
are in closed position.
Care And Maintenance