Paradyne HOTWIRE
8610 DSLAM, Руководство по установке

Страница: 48 / 56

A. Pinouts
A-4
April 2001 8610-A2-GN20-10
Telco 50-Pin Connector Pinouts for DSL Loops and POTS Splitters
The three Telco 50-pin receptacles on the rear of the
chassis (labeled for Slots 1, 2, 3) provide the 2-wire loop
interface from each DSL port to either the POTS splitter
card or, if the loop is not being shared with POTS, then
to the Main Distribution Frame (MDF). The following
table lists the pin assignments for each of these
interfaces.
NOTE:
When the 8610 chassis is the base chassis, the MCP is installed in Slot 1 and
the Tips and Rings for Slot 1 are not connected internally and are not active.
CONN #
for Slots 1–3 CONN PINS
(Tip, Ring) CONN #
for Slots 1–3 CONN PINS
(Tip, Ring)
Port 1 1, 26 Port 14 14, 39
Port 2 2, 27 Port 15 15, 40
Port 3 3, 28 Port 16 16, 41
Port 4 4, 29 Port 17 17, 42
Port 5 5, 30 Port 18 18, 43
Port 6 6, 31 Port 19 19, 44
Port 7 7, 32 Port 20 20, 45
Port 8 8, 33 Port 21 21, 46
Port 9 9, 34 Port 22 22, 47
Port 10 10, 35 Port 23 23, 48
Port 11 11, 36 Port 24 24, 49
Port 12 12, 37 Port 25 25, 50
Port 13 13, 38
26
97-15526
50
1
25