3
8343-A2-GZ40-00
January 2000
Installing the SDSL Card
"
Procedure
To install the Hotwire 8343/8344 Packet SDSL Card in a Hotwire chassis:
1. If there is a filler plate covering the slot, remove it.
2. Insert the card into the card guides of the slot on the chassis. For the 8343
SDSL card in an 8610 DSLAM, ensure that the components are facing up.
3. Carefully slide the card into the slot. Gently, but firmly, push the card until it
engages its mating connectors on the backplane.
4. Verify that the OK SYSTEM indicator on the card’s faceplate is blinking
(green). If not, refer to the appropriate chassis installation document.
5. Secure the card by fastening the screws on each end of the faceplate. This is
required to maintain proper gasket pressure on the faceplate as well as
proper air flow.
SDSL Card Technical Specifications
Specifications
Criteria*
Size
Length: 10.4 inches (26.42 cm)
Height: 11.15 inches (28.32 cm)
Width:
0.8 inches (2.03 cm)
Weight
Approximately 1.4 lbs. (0.64 kg)
Approvals
Safety Certifications
Refer to the equipment’s label for approvals on product.
Power
The SDSL card contains a dc-to-dc converter that requires
– 48V power input. The – 48V power is distributed through
the Hotwire chassis backplane.
Maximum Power Dissipation = 36 watts
Physical Environment
Operating temperature
Storage temperature
Relative humidity
Shock and vibration
32
°
to 122
°
F (0
°
to 50
°
C)
– 4
°
F to 158
°
F (–20
°
C to 70
°
C)
5% to 85% (noncondensing)
Withstands normal shipping and handling.
* Criteria of technical specifications are subject to change without notice.
