10
Connecting to the Network
Now that the FrameSaver unit is set up, the unit can be connected to the network.
Procedure
1. Use the supplied 6-pin cable for the DSL connection. Insert one end of the cable
into the DSL network interface.
2. Insert the other end of the cable into the modular jack labeled NET.
DSL
Network
00-16685-01
ETHERNET
P
O
R
T
COM
POWER
NET
3. Verify that the Network signal (DSL) LED is green. If so, the network interface is
set up correctly and is operational. If not, make sure both ends of the network
cable are properly seated.
4. Check Health and Status messages in the left column of the System and Test
Status screen.
Main Menu
→
Status
→
System and Test Status
