Paradyne BitStorm 2461, Руководство по установке

Страница: 15 / 64

1. Installation
2400-A2-GN20-20 December 2002
1-3
In addition, you will require:
„
A length of 14 AWG wire for an earth ground
„
A length of 16 or 18 AWG wire for DC power (DC-powered model only)
Unpacking the Hardware
HANDLING PRECAUTIONS FOR STATIC-SENSITIVE
DEVICES
This product is designed to protect sensitive components from damage
due to electrostatic discharge (ESD) during normal operation. When
performing installation procedures, however, take proper static control
precautions to prevent damage to equipment. If you are not sure of
proper static control precautions, contact your nearest sales or service
representative.
The BitStorm 2400 is shipped in a cardboard shipping container. Carefully remove
the unit from its shipping container and check for physical damage. If the unit
shows signs of shipping damage, notify your sales representative.
!
Package Contents
In addition to this installation guide, the BitStorm 2400 shipping carton should
contain:
„
BitStorm 2400
„
Mounting Brackets (one left and one right) for 19-inch (483 mm) rack
„
North American Power Cord (AC model only) – 6.5 ft (1.98 meters)
„
Connector hold-down strap
„
Ferrite choke and instructions
„
Nylon cable ties
„
Hardware kit (see Table 1-2, Contents of Hardware Kit Shipped with the
BitStorm 2400 )
If anything is missing, notify your sales representative.
Before installing the BitStorm 2400, read the Important Safety Instructions in the
beginning of this document.
Be sure to register your warranty at www.paradyne.com/warranty
!