Installation Page 15
Chapter 4: Installation
To improve RF reception an optional external antenna can be
installed together with an extension cable.
Antenna Extension Installation (Optional)
To Install the Antenna Extension:
1)
Use the mounting bracket to mark the holes onto the
mounting surface.
2)
Drill the holes and insert the antenna extension in the
bracket until it snaps into place.
3)
Align the bracket and secure into place using the
appropriate mounting hardware.
Note
: There are two knockout holes in the PCS250 enclosure.
The one located at the top of the enclosure is used for an
extension cable while the other one is used if an external
antenna is installed on the box (rod antenna).
Module Installation
The PCS250 must be securely mounted on a wall or similar
surface. It is important to mount it as far away as possible from
any electronic equipment. Ensure that it is mounted as high as
possible to ensure protection from RF interference.
To Mount the PCS250:
1)
Use the module as a template to mark the five holes onto
the mountings surface (four mounting, one tamper).
2)
Drill the holes.
3)
Align the PCS250 and secure into place using the
appropriate hardware, as shown in Figure 4.
Figure 4: Mounting the Module
