Paradox omnia OMN-RCV3, Справочное и монтажное руководство

Страница: 8 / 28

6 Reference & Installation Manual
3.0 PROGRAMMING
To successfully install an Omnia wireless system to your Spectra system, ensure
that the following steps are completed:
1. Install the Omnia Receiver. Connect the Omnia Receiver to the Spectra control
panel and power up.
2. Assign the remote controls if necessary.
3. Assign the transmitters (door contacts and motion detectors), and program their
zones.
4. Install the transmitters. Insert the batteries, and close the transmitter cover.
5. Wait for the control panel to be in “ready” mode. The status light on the keypad
will be green when the control panel is ready.
6. In order to ensure proper synchronization between the transmitters and receiver,
open and close the transmitters’ covers and zones.
3.1 HOW TO ENTER PROGRAMMING MODE
Programming of the OMN-RCV3 is done in Programming Mode through any keypad
connected to the Spectra control panel.
The OMN-RCV3’s programming guide can be found in the appropriate
Spectra Programming Guide.
3.2 WIRELESS TRANSMITTER PROGRAMMING
The programming of the wireless transmitters (detectors and door contacts) is
accomplished in two steps:
1. Assigning the detectors and door contacts to the Wireless Receiver Module.
2. Programming the zones in the Spectra control panel.
How to enter programming mode.
1. Press the [
ENTER
] button.
2. Enter your [
INSTALLER CODE
] (default = 000000).
3. Enter the [
SECTION NUMBER
] you wish to program.
4. Enter the required [
DATA
] .