20
•
Griddle Assembly
HSL-32 Hibachi Griddle Operator Manual
Install the Griddle
Complete this procedure to install the griddle into the island:
1.
Remove the griddle plate:
a.
Remove the two shipping screws as shown in Figure 9 (left) and store them in a safe place
Figure 9 Remove Griddle Plate
b.
Use the handle on each side of the griddle plate, lift it clear of the firebox, and set it on a
clean, sturdy, flat surface
NOTE
: The griddle plate weighs approximately 45 pounds; use caution when lifting.
2.
Check each burner for obstruction:
a.
Remove one burner at a time – lift the back end of the burner, then pull it out of the front
panel
b.
Look into the burner tube to check for any foreign particles, and remove with cold water
and a brush if needed
c.
Ensure the burner air shutter (Figure 10, left) is positioned appropriately for the gas source;
the shutter should be opened to about 3/8” for LP gas or 1/8” for NG
Figure 10 Burner Air Gap
