MAINTENANCE
Drive Clutch
Assembly
Drive Clutch
Assembly
Light oil
only
Shaft adaptor
Figure 5.
Figure 6.
Figure 7.
Battery Maintenance - Charging
The battery supplied with your Lectronic Kaddy should
be charged immediately after every round of golf.
Do not use any other type of charger to charge the
battery. Serious damage or personal injury could result.
To charge the battery, plug in the polarized battery
connector to the charger, ensuring the charger is
plugged into a live outlet. The charger will
automatically switch to a standby mode at the end of
the charge cycle, thus being safe for long term
connection.
Always leave the battery connected to the charger and
the charger connected to the AC power until you need
the battery.
Do not charge the battery while it is still in the Kaddy.
WARNING: Use only Lectronic Kaddy
approved batteries on your Lectronic
Kaddy charger.
WARNING: Leaving a battery in a
discharged or semi-discharged state is
the leading cause of premature battery failure.
General:-
Clean off excessive dirt after use.
Wipe over with a damp cloth.
Periodically lubricate folding mechanism joints with a
light oil.
Remove wheels by depressing locking tab.(see figure 5.)
and sliding wheel off the axle.
Remove drive clutch assembly. Shaft adaptor will
remain on the axle.
Using light oil, lubricate the inside of the clutch bearing
as shown in figure 7.
Note: Ensure that each clutch assembly is returned to the
side from which it was removed. Should they be re-
versed, the Kaddy will not move forward.
