PAR EverServ ® 7700/7200 POS Terminal Setup Guide
Connecting Your Peripherals
Remove Covers to Access Connection Panels
1. Set the terminal on a flat, clean surface and tilt the
display head horizontally to the table to access cable
well covers.
2. Remove the cable well cover by pressing the two
side tabs, and pulling it away from the register
3. Loosen the two thumb screws on the pedestal cover
and slide out toward the front of the register. See the
picture below.
DC Power Cable
6. Route the AC power cord to the power supply by going through the pedestal of
the terminal and connect it to the power supply. See the picture below.
Cable Well
Connect Peripherals to POS Terminal
All peripheral connections will be made in the
cable well on the underside of the top cover.
1. Connect the DC Power cable.
2. Next, connect the cash drawer cable, network
cable, and printer cable. Customer display cable
and MSR cable should be pre-connected from the
factory.
Refer to the “Cable Well” diagram located in the
middle of the page.
3. Gather the cables in one hand and replace the
cable wall cover by clipping the retaining clamps
back into place.
4. Next, tighten the two thumb screws on the
pedestal cover.
4. Unclip the retaining clamp to access the cables.
5. Lift the cut out at the base and pull forward.
Loosen thumb
screws and pull
panel forward
1. Two USB 2.0 Ports 7. COM Port 5 Customer Display 14. CD 2 (Cash Drawer Port 2)
2. Two USB 3.0 Ports
(M7700 only)
8. Audio Line Out
(M7700 only)
15. 12V Power Out
Two additional USB 9. DVI-I Video Port 16. 19V Power Input
2.0 Ports
(M7200 only)
10. 24V Power USB 2.0 Port 17. Diagnostic LED
3. COM Port 1 11. 12V Power USB
(M7700 only)
18. Power Switch
4. COM Port 2 12. 12V Power USB
(M7700 only)
19. PS/2 Port
5. COM Port 3 (powered) 13. CD 1(Cash Drawer Port 1) 20. LAN Port
6. COM Port 4 (powered)
Power on the POS Equipment
Ensure
that the unit powers on by switching on the black
power button that is indicated on the “Main
Cable Well” diagram located in the middle of the
page.
Connecting USB Devices
M7700:
Two USB 2.0’s ports
Two 12V powered USB 2.0 ports
One 24V powered USB port
Two 3.0 USB ports
M7200
Four USB 2.0 ports
One 24V powered USB 2.0 port
[©Copyright 2014 ParTech, Inc. All rights reserved.] page 2 772230806
