H-1 Cylinder cutting machine
www.paperfox.eu
4
If the tool has parallel lines with the cylinder the
place the tool angled on the table.
In this way you can avoid the unnecessary stress in the machine which occurs when
the machine has to cut a long line at once.
You can stick paper stops to the tool to position the sheet to cut. Stick a piece of card
on soft foam like on the picture.
Place a VLPOM cutting plate on the sheet which you want to cut.
Now you can set the optimal height of the cylinder. Lift up the cylinder with the
cylinder setting screws so that the tool with the plates could pass under the cylinder
without touching it. Then move the cylinder down so that it touches the cutting plate.
Paper sheet
Paper stops
Plastic or metal plate
under the cutting tool
Cutting plate
