(1)
、
When you are finished using your keyboard or you will be required after the keyboard to carry , so don't
forget to set aside the keyboard to switch the source OFF, turn off the keyboard's power to extend battery life
(2)When you need a long time storage your keyboard, please don't forget to pack the battery power, about half
of the filling , then store your keyboard, so can make your keyboard lithium life longer.
FAQ:
1.
If unable to connect the Bluetooth Keyboard to the computer, or the Keyboard work unconventionally, please
try the steps below:
(1),Before you install your Bluetooth Keyboard, please make sure you have done the Bluetooth Dongle
installation procedure, and the Bluetooth facility is turned on.
(2),Press and release the connect button on the bottom of Bluetooth Keyboard. The red led light will change into
a flashing mode.
(3),Make sure that the keyboard is within the effective range---10M.
(4),Make sure that there’s no change of the Bluetooth facility. If anything changed, please kindly rematch.
(5),If your Bluetooth facility is connected to other Bluetooth products, please kindly confirm that the speed of the
Bluetooth facility is enough.
(6),Please kindly check the batteries. If they are short of power, replace them for new ones.
(7),Please make sure that your Bluetooth Dongle is damaged or not .
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device.
Pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if no installed and used in accordance with the
instructions, may cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
●
Reorient or relocate the receiving antenna
●
Increase the separation between the equipment and receiver.
●
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected
●
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
FCC Caution: Any change or modifications no expressly approved by the party responsible for
compliance could void the user’s authority to operate this equipment.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
1. This equipment complies with FCC radiation exposure limits ser forth for an uncontrolled
environment. End users must follow the specific operating instructions for satisfying RF exposure
compliance.
2. This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
