Paoli Avvitatori DP 1050, Руководство по эксплуатации и техническому обслуживанию, Страница: 13 / 52

ENGLISH
Translations of the original operating instructions -
The original language of these instructions is Italian.
OPERATING AND MAINTENANCE MANUAL
13
L
“Square drive without hole and with
retainer ring”: Insert the accessory “A” in
the square drive of the tool, with an axial
pressure ( view figure Fig.4 ).
When changing accessory, always disconnect
the pressure lines.
Use only accessories suitable for the job.
ACCESSORIES ASSEMBLY
L
Indicate the parts most subject to wear,
to be dismantled and checked at regular
intervals, as well as a list of malfunctions, if
any, and the corrective action.
L
If the tool is left unused for long periods
we recommend putting some oil into the
air inlet and letting it run for a few seconds
before putting it away. In this way the internal
components will remain lubricated.
L
Spare parts can be purchased in the “service
kit” package. Details of the service kit
components are available on our general
catalogue.
L
Every three weeks clean the motor by
introducing naphtha (~25cc) through the
air inlet, while keeping the trigger pressed;
then running the wheel gun clockwise and
anticlockwise. After the inside washing,
repeat the previous operation with oil for
air tools (~5cc). These operations must be
performed in a suitably equipped working
environment, complete with extraction
equipment for nebulised particles. Use
personal protective equipment.
L
Drain condensation at the air filter and the
compressor daily ( view figure Fig.1 ).
MAINTENANCE
Separate the components on the basis of the nature of the materials of which they are made.
SCRAPPING
L
If you have used a lower torque, screw
on again using an appliance with the
right torque, in order to avoid the risks of
insecure tightening.
L
If you avoid operating at a higher pressure
than the one required you will save energy,
make less noise, and have less wear on the
appliance.
L
Always use an impact wrench with the
tightening torque corresponding to the one
required by the application.
L
If by mistake you have used a higher torque
than the one required:
⚪
in the case of screwing, replace the bolt
and reform the tread you screwed it onto,
because of it yielding;
⚪ in the case of unscrewing, replace the
bolt anyhow and check the tread you
screwed it onto.
OPERATING INSTRUCTIONS