Installation PANTHERA ASC Sound Module
1.
Connect the PANTHERA ASC Sound Module to the 12 PIN connector of the PTR-
CONASC Harness.
2.
Now run the installation check.
Installation check of PANTHERA ASC Sound Generator
1.
Start the engine of the vehicle, the green LED of the PANTHERA ASC Sound Module
will pulsate. And the yellow and green LED of the OBD dongle starts to flash.
Now press vigorously the accelerator during idle and listen to the PANTHERA Leo
Sound Generator.
1.
Start the engine of the vehicle.
OBD Dongle LED description:
Yellow is lighting = Bluetooth connection to the Leo module is active.
Green is flashing = Data will receive from the ECU (engine control unit).
Red is lighting = Error.
Off (no LED is on) = OBD Dongle is in standby mode.
Leo ASC Sound module LED description:
Green is pulsating = OBD Dongle is connected and data will receive from the OBD
Dongle / Engine control unit.
Blue is pulsating = Smartphone is connected to the ASC Sound Module.
Yellow is pulsating = only connection to the OBD dongle without receiving data
from the ECU
White is interrupting flashing = Modification on the LEO ASC Sound Module
(Smartphone or remote control) .
Red is pulsating = Error.
Please note, that every first time, when the OBD dongle is plugged into the OBD
Port, the pairing between OBD Dongle and ASC Sound Module needs up to 2 or 3
seconds. After this pairing, the boot time is only some milliseconds.
If you do not receive data from the OBD dongle / engine control unit, please
disconnect the OBD dongle and connect it again!
The team of PANTHERA wishes you a lot of fun and at all time a good trip!
