Panthera AB, Gunnebogatan 26, SE-163 53 Spånga, Sweden, +46-8-761 50 40, www.panthera.se
The lateral upport can be mounted in two different ways to give different widths between the cushions.
Decide width mounting
1. Select position on the metal arm Fig.2
2. Make sure the plastic bushing (fig1. Pos 3)inside the metal arm is
entered from above (fig 3-5)
3. If the cushion is on the wrong side on the lateral support (fig.1 pos.1),
fix this by removing the screws (Fig 1. Pos.5) that holds the cushion, use
a 6 mm Allen key.
4. Remove the cover (Fig 1. Pos 4) and cushion and move the cushion to
the opposite side, put the lid back and screw it on.
1)
Press the snap 1 to loosen the bushing
Fig 2
2)
Press snap 2 to remove the bushing
3)
Install the bushing from the other side
How to loosen plastic bushing
6)
Mount the lateral support over the back tube
until it stops against the bolt.
7)
The lateral support is in place. Refit the end
plug and screw on the upper part of the uphol-
stery, fold back the upholstery fabric.
Fig 3
Fig 4
Fig 5
wide-adjusted
narrow-adjusted
18mm smaller