2
128-9107
2 of 8
OPERATING ON AUTOMATIC START UP TIMER MODE
Your system has the ability to automatically start the vehicle every 2 or 4 hours over a 48 hour period. This
feature is especially useful in cold climates where the only means to keep the engine and engine fluids warm
is to periodically start the engine.
WARNING!
Be certain that the vehicle is outdoors before using this or any remote vehicle starting device. A
running engine produces dangerous carbon monoxide fumes which can be harmful or fatal if
prolonged exposure occurs. DO NOT remote start the vehicle if it is garaged.
TO BEGIN THE AUTOMATIC START UP TIMER
1. Turn the ignition key on then off.
2. Within 10 seconds, activate the RF start command two times. (Press the programmed channel
button of your keychain transmitter 4 times).
The parking lights will flash and the siren will chirp 2 or 4 times indicating the timed start mode is activated.
The vehicle, on a 2 or 4 hour interval basis, dependent on the number of chirps heard when activated
as described above will automatically start, run for the pre-programmed time (5,10,15 or 20 minutes),
and then shut off. This will continue for 48 hours.
NOTE:
The automatic start up timer can also be initiated from the keychain transmitter.
To do this:
1. Start the vehicle using the keychain transmitter by pressing and releasing the
second channel transmitter button 2 times.
2. Shut off the vehicle using the keychain transmitter by pressing and releasing the second channel
transmitter button 2 times.
3. Within 10 seconds of step 2, activate the RF start command two times.
(Push the second channel button of your keychain transmitter 4 times).
The parking lights will flash and the horn will chirp 2 times to indicate a 2 hour start interval, or 4 times to
indicate a 4 hour start interval. The 2 or 4 hour start sequence is selected at time of installation during the
feature setting mode. Please consult with your installation center if you wish to have this interval changed.
CANCELING THE AUTOMATIC START UP TIMER
To cancel the automatic start up timer do one of the following;
1. Start the vehicle manually with the use of the ignition key and depress the brake pedal.
2. Remote start the vehicle using your keychain RF transmitter.
PROGRAMMING TRANSMITTERS:
At times it may become necessary to program replacement or additional transmitters for use with your
system. To do this:
1) With the system unlocked or disarmed, turn the ignition key to the on position.
2) Press and release the Program/Override push-button switch three times. The unit will flash the parking
lights and or beep the horn once to indicate that the system is in the transmitter program mode. The
LED will also flash one time pause, one time pause, etc... indicating that you are in the transmitter
program mode of the unit’s channel 1 or single button program mode.
3) Press and hold the lock button of each additional transmitter you wish to operate your system.
NOTE:
The unit is capable of storing up to 4 transmitters. If a fifth transmitter is added, the first transmitter
programmed will be removed.
Once all transmitter have been programmed, turn the ignition switch off to exit the program mode.
By completing the above, all three buttons of the transmitters are programmed into their default location.
Lock
=
Lock / Arm, & Panic
Unlock
=
Unlock / Disarm & Panic
Trunk/Key=
Trunk Release & Panic Cancel, Press & Hold 2.5 seconds to release trunk, Press while
Panic is sounding to cancel panic immediately. Press two times to start the vehicle.
Option
=
Consult your installaztion center for information on this feature.
