1.
Attach the swivel casters to the plates on
the bottom tray with the M8-1.25 x 25 bolts,
washers, lock washers and nuts. NOTE:
Only tighten the bolts finger tight until assem-
bly is complete.
2.
Attach the axle bracket to the rear cross
member with the M8-1.25 x 20 bolts, wash-
ers, lock washers and nuts.
3.
Slide the right and left axle braces over the
axle and attach to the adjacent cross-mem-
ber with the M8-1.25 x 20 bolts, washers,
lock washers, and nuts.
4.
Slide the wheels on the axle so the valves
are facing out. Slide on one 12mm washer
and thread an M12-1.75 on the axle to
secure the wheel.
ASSEMBLY INSTRUCTIONS
5.
Turn cart on side and attach the four posts
with M8-1.25 x 40 bolts, washers, lock wash-
ers and nuts through the bottom of the tray.
6.
Set the cart upright and attach the top tray
with M8-1.25 x 25 bolts, washers, lock wash-
ers an nuts.
7
. Slide the handle into the guides on the lower
tray and attach the M8-1.25 x 25 bolt, washer
and lock washer into the handle through the
bottom.
8
. Once all parts are assembled and aligned,
tighten all of the bolts.
If you need additional help with this procedure,
call our service department at: (570) 546-9663.
