In case of nominal currents corresponding to less than (or equal to)
100 A, fix the cable of the positive pole (red cable)
twice
through the
hole of the SmartUP module, then fix it with the fairlead at the side of
the module.
Make sure you have plugged the cable in the right direction: current
should flow from the charger to the battery through the SmartUP, so the
LEDs on the device should switch on from the bottom to the top during
charge.
In case of reverse connection tick on this button in the "Programming"
TAB (see below: 3.1), which is the current’s direction indicator.
2.
Software installation
Download the "Smart.View II" software from this
link
.
Connect the provided USB cable to a USB port on your computer.
Pointing towards the battery
