Sound Shower AA-160e / AA-160mm Operation Manual v.2.0 26.3.2012 ©
Panphonics Oy
2/7
ip update
Take new ip settings in use. After ”ip update” a new connection must be made and settings saved
by issuing ”save setup”. If the new settings are not saved after ”ip update” the unit will
reboot after about 5 minutes and return back to the old settings.
Usage: ip update
Output: NA
ip password
Change password of the ip connection. New password must be repeated twice after the command,
passwords are to be separated by a space character. The default password is 'passu'. Maximum
length of the password is 16 characters.
Usage: ip password passu passu
Output: OK
Changing standby mode ON/OFF
The amplifier standby mode can be chanced remotely using ‘PWRON’ / ‘PWROFF’ –
commands. The current status can be checked by using ‘STATUS’ command.
STATUS
Amplifier status query, returns ON/OFF depending on the amplifier state
Usage: STATUS
Output: STATUS24,OFF
PWRON
Amplifier power on command
Usage: PWRON
Output: STATUS03,ON
PWROFF
Amplifier power off command
Usage: PWROFF
Output: STATUS49,OFF
Selecting Input
The input interface can be selected using the ‘input’ –command. The default input is
RCA.
input x
Select audio input: 'input xlr', 'input rca'
Usage: input rca
Output: OK
Adjusting Volume
The current volume setting can be checked with ‘VOLREAD’ –command. The volume
can be changed by commanding ‘VOL00‘– ‘VOL37’. The minimum is ‘VOL00’ and the
maximum is ‘VOL37’. Any value between the 00 and 37 can be given. If the setting
should be permanent (even during the power failure), use the ‘VOLSAVE’ –command
to save the setting.
VOLREAD
Read current volume setting from the unit
Usage: VOLREAD
Output: VOL=22
VOLxx
Set volume VOL00-‐VOL37
Usage: VOL15
Output: STATUS00,ON
VOLSAVE
Save volume setting to Flash memory
Usage: VOLSAVE
Output: OK
