© 2001 PANORAMAdtv ALL rights reserved
14
VAMP-24
User Manual P/N
821515
Rev-
C
Please refer to Figure-1c on the following page to familiarize yourself with the rear panel features of the VAMP-24
unit. The following sections describe these features and are referenced, by letter, to Figure-1c.
A Power - IEC-320 Connector
Attach a standard IEC-320 power cord between this connector and mains power.
Τ
he front panel Power
LED (Item 8) will glow green to indicate that an operating voltage is present.
B Audio Inputs VTR-A (Bank A) - Phoenix Connectors
Connect four channels of analog audio signals here from a VTR or other source. The VTR-A (Bank A)
connectors are interleaved with the VTR-B (Bank B) connectors (Item C). If the Audio Source select
switch (Item 10) on the front panel is set to "A", then the four VTR-A channels will be available for
selection for monitoring through the speakers (or headphones) via the Left and Right Speaker Source select
switches (Item 12) on the front panel. Also, with this setting, all four channels of VTR-A input signals will
be simultaneously displayed on the four level meters. Connector pin-out information is silk-screened
below each of the VTR-A connectors. Audio source selection is independant from the video source
selection.
C Audio Inputs VTR-B (Bank B) - Phoenix Connectors
Connect an additional four channels of analog audio signals here from a second VTR or other source. The
VTR-B (Bank B) connectors are interleaved with the VTR-A (Bank A) connectors (see Item B). If the
Audio Source select switch (Item 10) on the front panel is set to "B", then the four VTR-B channels will
be available for selection for monitoring through the speakers (or headphones) via the Left and Right
Speaker Source select switches (Item 12) on the front panel. Also, with this setting, all four channels
of VTR-B input signals will be simultaneously displayed on the four level meters. Connector pin-out
information is silk-screened above each of the VTR-B connectors. Audio source selection is independant
from the video source selection.
D Video Inputs - Composite (A and B) - BNC Connectors
Connect standard composite analog video signals here. There are two inputs; A and B. Either can be
selected for monitoring on the front panel LCD Monitor Screen (Item 6) by setting the Video Source select
switch (Item 4) on the front panel to either A or B. PAL and NTSC video signals are automatically
detected and configured for monitoring on the LCD monitor. Video source selection is independant from
the audio source selection.
E External speakers - Terminal Posts
Connect external speakers here using these terminal posts. The left pair outputs the signals as selected for
the left speaker while the right pair outputs the signals as selected for the right speaker. Terminal posts in
each output pair are color coded for polarity; red is positive (left post) and black is negative (right post).
An external amplifier is not needed to drive the external speakers.
F Selected Analog Output - XLR Connectors
These two connectors are analog outputs of the source as selected for the left and right speakers. Pin-out
information is shown below.
Rear Panel Features
Section 2: Operation
